Ledger Board Over Siding

Should i look at at maybe installing the ledger over the top of the hardiplank using shims.

Ledger board over siding.

Start by making an outline on the siding where you want to position the ledger board. The attach a deck is a simple deck ledger mounting system that stands the ledger off the wall eliminating the need for flashing that s the big benefit but there are other features i like. Ledger board overlapping siding below it. Attach a deck can be used to mount ledgers on new homes and retrofit decks over siding on existing homes the system is tested by an engineering service the installation is simple and fast lag screws.

Never install a ledger board over the top of siding no matter what you hear this can weaken the connection. They said this was intentional so that water wouldn t get behind the siding underneath the ledger. Make sure to install flashing under the siding extending over the ledger the flashing prevents the build up of moisture which causes rotting. Nail undersill trim j channel will also work over the bottom cut using 11 gauge aluminum nails.

Are there any gotchas im missing on attaching the ledger board. Aluminum and vinyl siding can easily be removed with tin snips from an area one foot surrounding the ledger board location. Detecting and correcting deck ledger problems around vinyl siding. Here are the steps to take when installing a ledger on a home with siding.

Properly installing a ledger board for your deck is one of the most important structural components of building a safe and strong deck. The ledger board is a horizontal framing member usually two by 10 or two by 12 lumber that supports one side of a deck and attaches flat to the wall of a house after removing a section of siding. Detecting and correcting deck ledger problems around vinyl siding. Also is it going to be hard to slide the flashing underneath the hardiplank siding.

These 18 articles will teach you how to install flashing and bolt the ledger connection to the house rim. The following steps will explain an easy method of removing the lap siding and attaching a ledger board. Step 1 determine the size of the ledger board to ensure proper strength a ledger board should be made out of the same size lumber that was used to make the deck joists usually 2 inch by 10 inch boards. Then cut away the siding.

In order to install the ledger board you usually need to remove the house s siding. Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.